RPB® GX4 08-401-01 GAS MONITOR WITH 12V DC Battery Clamps

<< Previous in CO Monitors

Next in CO Monitors >>

Price: $2,795.00

RPB® GX4 GAS MONITOR WITH 12V DC Battery Clamps

Item Number: GX4-12V

Manufacturer: RPB

Manufacturer Part No: 08-401-01-12V

Email this page to a friend

RPB® GX4 08-401-01 GAS MONITOR WITH 12V DC Battery Clamps, 10 PPM CO CARTRIDGE & MOUNTING BRACKETS. The RPB® GX4, Model 08-400, tests the quality of compressed breathing air for Carbon Monoxide and other gases*. Compressed Air is supplied to the unit through the sampling hose at a constant flow to the sensors for continuous analysis. The monitor must be supplied with Grade D air and must be free of oil and water to prevent contamination of the sensors. A micro-mist filter prior to the Radex air filtration system is recommended to protect the GX4 and the operator(s). Check with your local regulatory bodies for more information on local requirements. The monitor operates at 12 volts DC and can be used with either the 110/240v AC Adaptor (P/N: 08-430) or the 12v cable with Battery Clips (P/N: 08-431). The unit is designed to operate in temperature ranges of 14° to 120F (-10 to +50C) and Humidity levels of 5% - 99% (no condensation). The RPB® GX4 when used with the Carbon Monoxide Sensor Cartridge (P/N: 08-420-01) satisfies the requirements of OSHA rule 29 CFR 1910.134 for carbon monoxide monitoring..

KEY FEATURES:

- Multiple gasses monitored simultaneously
- Traceability of gas levels, temperature, alarms, air flow, sensor checks and more
- Internal web server for remote monitoring, reviewing logs and printing reports
- 3 inch LCD display and 6 buttons to easily navigate the menus
- Exterior lights and alarms
- Auxiliary output for external alarms, strobe lights or solenoids
- Tamper switch sealed inside of unit
- Robust protective housing
- Tamper Proof ( No Adjustment Required)
- Field Replacement Cartridges
- Sealed Electronics
- Wireless Connections To Unit With Portable Calibration Readings
- Ease Of Calibration With A Pass Or Fail Result
- Mounts to a Radex filtration system
- Weight: 5.0 Lbs. (2.268 Kg.)

- Optional wall mount bracket
- Optional protective travel case.

The RPB® GX4 IS A MONITOR AND DOES NOT REMOVE ANY GASSES FROM THE AIR & IS NOT APPROVED FOR USE IN HAZARDOUS OR EXPLOSIVE ATMOSPHERES

WIFI CONNECTION

To unleash the full power of the GX4, it is recommended to connect it to the internet via the built-in wireless network transceiver. This connection allows easy firmware upgrades and the unit hosts a website available to devices on that network. Use the website to stream real-time gas levels, search through logs or print reports.

Only gasses relating to the inserted cartridges can be detected. Visit rpbsafety.com for a list of available gas sensors.

*Should the need arise, the unit must be returned to RPB® Safety to perform any repairs. Other then replacing filters do not open case for any reason. Do NOT remove any part of the GX4, especially the air inlet fitting or the power and auxiliary receptacles under any circumstances. Removing any part will void all warranties.

Place the GX4 in a place that the alarm can be heard & is protected from water and impact. Leave work area immediately if the monitor alarm sounds, check air source and wait until alarm mode stops. If it continues, verify sensor calibration or change your air source.

WARRANTY

This RPB® Safety product is covered by a manufacture’s warranty of 1 year. The manufacturer warranty covers defects in material, workmanship and does not cover damage caused by misuse or abuse. RPB® Safety’s only obligation and your exclusive remedy shall be to repair, replace or refund the purchase price of such parts or products upon the presentation of proof of purchase. Maximum liability is in no case to exceed the value of the RPB® Safety Product involved.

RPB® Safety is not liable for damage, loss or expense resulting from the failure to give advice or information or the giving of incorrect advice or information, whether or not due to RPB® Safety’s negligence or that of it’s employees, agents or sub-contractors. RPB® Safety cannot accept any liability of whatsoever nature arising directly or indirectly from the use or misuse of RPB® Safety products, including purposes that the products are not designed for. Do not use this unit until you have been trained in its operation by a qualified individual appointed by your employer. Failure to adhere to the user’s instruction manual could result in serious injury or death. Do not open the monitor casing. The unit is sealed closed and equipped with a tamper switch. If the tamper switch is activated and/or the seal is broken it will void all warranties. Sensors may contain sulfuric acid or other hazardous chemicals which are poisonous, can cause burns or eyesight loss. Do not allow contact with skin or eyes. If eyes are exposed to the chemicals flush thoroughly and seek medical attention. Always wash hands thoroughly after handling a sensor cartridge.

For Your Own Health Silica Sand Is Not Recommended And For Legal Reasons Voids The Warranty, Though Sand Will Flow Easily Through This Machine. Breathing Dust From Silica Sand May Cause Silicosis, A Fatal Lung Disease. Breathing Dust During Blasting Operations May Also Cause Asbestosis And/Or Serious Other Diseases. A NIOSH Approved And Well-Maintained Air Supplied Abrasive Blasting Respirator Must Be Used By Anyone Blasting, Anyone Handling Or Using The Sand And Anyone In The Area Of The Dust. Harmful Dust Can Remain Suspended In The Air For Long Periods Of Time After Blasting Has Ceased, Causing Serious Injury Or Death

Any damages or shortages MUST be noted on the carrier receipt at the time of delivery. Notify the carrier and Construction Equipment & Supply Co. immediately and we will assist you as fully as we can. Please retain a signed copy of the bill of lading or delivery receipt for your records.