RPB 08-461 CALIBRATION CO TEST GAS 20PPM FOR GX4 GAS MONITOR

<< Previous in CO Monitors

Next in CO Monitors >>

Price: $125.00

Item Number: CO TEST GAS

Manufacturer: RPB

Manufacturer Part No: 08-461

Email this page to a friend

RPB 08-461 CALIBRATION CO TEST GAS 20PPM FOR GX4 GAS MONITOR. GX4 Gas Monitor Or GX4 ZERO GAS Sold Separately.

A HAZARDOUS MATERIALS CHARGE OF $50.00 PER ORDER (NOT PER UNIT) APPLIES TO THIS PRODUCT - SHIPS DIRECTLY FROM MANUFACTURER]

* Weight: 2.2 Lbs. (0.998 Kg.)

The RPB® GX4 IS A MONITOR AND DOES NOT REMOVE ANY GASSES FROM THE AIR & IS NOT APPROVED FOR USE IN HAZARDOUS OR EXPLOSIVE ATMOSPHERES

WIFI CONNECTION

To unleash the full power of the GX4, it is recommended to connect it to the internet via the built-in wireless network transceiver. This connection allows easy firmware upgrades and the unit hosts a website available to devices on that network. Use the website to stream real-time gas levels, search through logs or print reports.

Only gasses relating to the inserted cartridges can be detected. Visit rpbsafety.com for a list of available gas sensors.

*Should the need arise, the unit must be returned to RPB® Safety to perform any repairs. Other then replacing filters do not open case for any reason. Do NOT remove any part of the GX4, especially the air inlet fitting or the power and auxiliary receptacles under any circumstances. Removing any part will void all warranties.

Place the GX4 in a place that the alarm can be heard & is protected from water and impact. Leave work area immediately if the monitor alarm sounds, check air source and wait until alarm mode stops. If it continues, verify sensor calibration or change your air source.

WARRANTY

This RPB® Safety product is covered by a manufacture’s warranty of 1 year. The manufacturer warranty covers defects in material, workmanship and does not cover damage caused by misuse or abuse. RPB® Safety’s only obligation and your exclusive remedy shall be to repair, replace or refund the purchase price of such parts or products upon the presentation of proof of purchase. Maximum liability is in no case to exceed the value of the RPB® Safety Product involved.

RPB® Safety is not liable for damage, loss or expense resulting from the failure to give advice or information or the giving of incorrect advice or information, whether or not due to RPB® Safety’s negligence or that of it’s employees, agents or sub-contractors. RPB® Safety cannot accept any liability of whatsoever nature arising directly or indirectly from the use or misuse of RPB® Safety products, including purposes that the products are not designed for. Do not use this unit until you have been trained in its operation by a qualified individual appointed by your employer. Failure to adhere to the user’s instruction manual could result in serious injury or death. Do not open the monitor casing. The unit is sealed closed and equipped with a tamper switch. If the tamper switch is activated and/or the seal is broken it will void all warranties. Sensors may contain sulfuric acid or other hazardous chemicals which are poisonous, can cause burns or eyesight loss. Do not allow contact with skin or eyes. If eyes are exposed to the chemicals flush thoroughly and seek medical attention. Always wash hands thoroughly after handling a sensor cartridge.

For Your Own Health Silica Sand Is Not Recommended And For Legal Reasons Voids The Warranty, Though Sand Will Flow Easily Through This Machine. Breathing Dust From Silica Sand May Cause Silicosis, A Fatal Lung Disease. Breathing Dust During Blasting Operations May Also Cause Asbestosis And/Or Serious Other Diseases. A NIOSH Approved And Well-Maintained Air Supplied Abrasive Blasting Respirator Must Be Used By Anyone Blasting, Anyone Handling Or Using The Sand And Anyone In The Area Of The Dust. Harmful Dust Can Remain Suspended In The Air For Long Periods Of Time After Blasting Has Ceased, Causing Serious Injury Or Death

Any damages or shortages MUST be noted on the carrier receipt at the time of delivery. Notify the carrier and Construction Equipment & Supply Co. immediately and we will assist you as fully as we can. Please retain a signed copy of the bill of lading or delivery receipt for your records.

RPB 08-461 CALIBRATION CO TEST GAS 20PPM FOR GX4 GAS MONITOR

Related Products

RPB® GX4 08-400-01 GAS MONITOR WITH 120V AC (U.S.A.) ADAPTOR

RPB® GX4 08-401-01 GAS MONITOR WITH 12V DC Battery Clamps